# Making an electronic busy board

DevFeed: [Making an electronic busy board](<https://devfeed.tech/articles/making-an-electronic-busy-board-112626.md>)

Original publisher: [Read original article](<https://blog.adafruit.com/2026/11/02/making-an-electronic-busy-board/>)

Author: Anne Barela

Published: 2026-11-02T20:19:18Z

Content type: article

Language: en

Sources: [Adafruit Industries](<https://devfeed.tech/sources/adafruit-industries-makers-hackers-artists-designers-and-engineers.md>)

Topics: [circuit](<https://devfeed.tech/topics/circuit.md>)

Tags: [7-segment](<https://devfeed.tech/tags/7-segment.md>), [aaa](<https://devfeed.tech/tags/aaa.md>), [busy-board](<https://devfeed.tech/tags/busy-board.md>), [buttons](<https://devfeed.tech/tags/buttons.md>), [code](<https://devfeed.tech/tags/code.md>), [components-parts](<https://devfeed.tech/tags/components-parts.md>), [display](<https://devfeed.tech/tags/display.md>), [displays](<https://devfeed.tech/tags/displays.md>), [driver](<https://devfeed.tech/tags/driver.md>), [electronic](<https://devfeed.tech/tags/electronic.md>), [electronics](<https://devfeed.tech/tags/electronics.md>), [firmware](<https://devfeed.tech/tags/firmware.md>), [gpio](<https://devfeed.tech/tags/gpio.md>), [graphs](<https://devfeed.tech/tags/graphs.md>), [hardware](<https://devfeed.tech/tags/hardware.md>), [led](<https://devfeed.tech/tags/led.md>), [low-power](<https://devfeed.tech/tags/low-power.md>), [microcontroller](<https://devfeed.tech/tags/microcontroller.md>), [pcb](<https://devfeed.tech/tags/pcb.md>), [pic](<https://devfeed.tech/tags/pic.md>), [projects](<https://devfeed.tech/tags/projects.md>), [toy](<https://devfeed.tech/tags/toy.md>)

## AI overview

The busy board uses a PIC18F67K40 and custom firmware to drive its displays and controls without dedicated driver chips. Its multiplexed LED and four-digit display are refreshed by six hardware timers; button presses use low-priority interrupts, allowing the timers to keep running during a 50 ms debounce delay. The 60-GPIO microcontroller uses every pin, and the board runs directly from three AAA cells without a voltage regulator. After 10 minutes without activity, it enters a low-power state drawing 374 nA.

## Source excerpt

andyc built an electronic toy for his nephew and wrote up the design at burningimage.net. It's called an electronic busy board. It has multi-colored LED bar graphs, a four-digit 7-segment display, push buttons, and a rotary encoder. The displays are multiplexed, so the firmware cycles through the digits faster than the eye can follow. Dedicated [...]